
	MEMTECH ACOUSTICAL NOISE CONTROL Industrial Noise Control, Noise Reduction Solutions, Noise Containment, Noise Dampening, Classroom Acoustics, Industrial Hygiene Services, Rapid Roll Doors, Pipe Insulation, Noisekiller

Memtech, Inc.
9033 General Drive
Plymouth, MI 48170

Phone: 800-634-4471

734-455-8550

Fax: 800-634-4472

734-455-8552

NOISEKILLER

A complete noise dampening product line for almost every type of noise or vibration, shock or impact problem

ORDER NOISEKILLER LIQUID PRODUCTS ONLINE

NoiseKiller liquid was created as a complete noise dampening product line for almost every type of noise or vibration, shock or impact problem. The idea is simple. Spray on NoiseKiller to stop unwanted vibrations and sounds in almost anything.

Instead of trying to cover up the sound, NoiseKiller Liquid works like a cure for the vibration problem. It actually gets rid of the vibration by converting it into low-grade heat. This "Viscoelastic" conversion is what happens when you use NoiseKiller Liquid.

Spray on NoiseKiller to stop unwanted vibrations and sounds in almost anything. Everything from a car that's too loud at freeway speed to a large factory with heavy equipment can benefit from the use of NoiseKiller products.

Examples of how NoiseKiller is used in today's modern industry:

Suggested Uses for NoiseKiller Liquid:
Manufacturing Stamping Equipment Car Audio Systems Street Rods Experimental Aircraft RVs	Vibratory Feeders Air Ducting Off Road Vehicles Auto Restorations Boats Home Appliances

Now NoiseKiller is available to everyone. Perfect for your home Street Rod or restoration project. Since it's water based, anyone can safely use it, plus mistakes are easily fixed with a wet rag. Better yet, it dries to a waterproof seal which means you won't every have to worry about it again.

Installation Instructions:
Clean any grease off the metal. Mask off areas where you don't want NoiseKiller.

Apply NoiseKiller Liquid to surface with a slow sweeping motion 10-12" away. Use 2 thin coats, building up to the thickness of the surface being sprayed. Wait an hour between coats. Allow 24 hours to cure for max sound damping.

NoiseKiller is waterbased so it cleans up easily with water. No sealing is required. When totally cured, NoiseKiller is waterproof and can be sanded and painted.

ORDER NOISEKILLER LIQUID PRODUCTS ONLINE

For immediate service email salesinfo@memtechacoustical.com

Do you have a problem with industrial noise?
It can come from a variety of sources and your employees don't like it and neither does OSHA. A recent survey found that the #1 factor employees believed would increase job performance was the ability to concentrate without noise and other distractions. Noise increases fatigue, shortens the attention span and if loud enough, can cause permanent damage.

back to Noise Dampening Page

top